ISO 527-2 — Tensile Properties of Plastics (Test Conditions for Moulding and Extrusion Plastics)
ISO 527-2 specifies the test conditions for determining the tensile properties of moulding and extrusion plastics. To match this to your program, talk with our team.
What ISO 527-2 Covers
It applies the general ISO 527-1 principles to moulded and extruded plastics, fixing specimen shapes and test speeds so results for these materials are comparable.
How the Test Is Run
A dumbbell specimen is pulled at a defined speed with strain measured over the gauge length, and tensile strength, modulus, and elongation are determined.
Why It Matters
Moulding and extrusion grades are qualified against ISO 527-2; consistent specimens and accurate strain measurement are essential.
Reading the Designation
Cited as ISO 527-2 with its edition year. Confirm the edition and specimen requirements before finalizing setup. To configure a plastics testing setup, request a quote.
TensileMill CNC products for ISO 527-2
Our specimen-preparation systems and testing equipment compatible with ISO 527-2.
TensileMill CNC MICRO – Precision Flat Tensile & Impact Micro Machine
MICRO – Precision Flat Tensile & Impact Sample Preparation
Electro Mechanical Universal Testing System 5 kN / 50 kN with Precision Load Cell
Electro-Mechanical UTM · 5 kN / 50 kN with Precision Load Cell
Set up ISO 527-2 testing with TensileMill CNC
Tell us your materials, specimen forms, and required test sections, and our team will match the right configuration.