DIN ISO 815-1 is the German adoption of ISO 815-1, the compression set method for vulcanized and thermoplastic rubber at ambient and elevated temperatures. To match this to your program, talk with our team.
What DIN ISO 815-1 Covers
It measures the permanent deformation remaining after prolonged compression of a rubber specimen, matching the ISO method under the German designation.
How the Test Is Run
A specimen is compressed in a jig, held at temperature, released, and the residual set is measured after recovery.
Why It Matters
Compression set characterizes seal durability; the DIN ISO designation is what German quality systems cite.
Reading the Designation
Cited as DIN ISO 815-1 with its edition year. Confirm the edition and specimen requirements before finalizing setup. To configure a rubber testing setup, request a quote.
Related Standards
ISO 815-1 is the base method and DIN ISO 815-2 covers low temperature.
Request a Quote
Setting up rubber compression set testing to DIN ISO 815-1? Request a quote and our team will help you build a system matched to your compound type and temperature.
TensileMill CNC products for DIN ISO 815-1
Our specimen-preparation systems and testing equipment compatible with DIN ISO 815-1:
Electro Mechanical Universal Testing System 5 kN / 50 kN with Precision Load Cell
Electro-Mechanical UTM · 5 kN / 50 kN with Precision Load Cell
Pneumatic Clamping Grips for Consistent Specimen Holding
Pneumatic clamping grips for consistent, high-cycle holding
Get ready for DIN ISO 815-1 with TensileMill CNC
Adding capacity or replacing older equipment? TensileMill CNC can support your DIN ISO 815-1 program. That typically means universal testing machines with pneumatic grips and cutting dies for rubber and elastomer specimens. Share your material mix and throughput, and we will recommend a setup that fits DIN ISO 815-1.