DIN 53504 is the tensile test method for the stress-strain properties of rubber and elastomers under a controlled rate. To match this to your program, talk with our team.
What DIN 53504 Covers
It determines tensile strength, elongation at break, and stress values at defined elongations for vulcanized rubber and elastomers in the German framework.
How the Test Is Run
A dumbbell specimen is pulled at a controlled speed with elongation measured over the gauge length, and the tensile properties are recorded.
Why It Matters
Rubber tensile data supports compound development and acceptance; low-slip grips and adequate travel for high elongation are needed.
Reading the Designation
Cited as DIN 53504 with its edition year. Confirm the edition and specimen requirements before finalizing setup. To configure a rubber testing setup, request a quote.
Related Standards
ISO 37 is the ISO rubber tensile method and ASTM D412 is the ASTM equivalent.
Request a Quote
Setting up rubber tensile testing to DIN 53504? Request a quote and our team will help you build a system matched to your compound type and elongation range.
TensileMill CNC products for DIN 53504
Our specimen-preparation systems and testing equipment compatible with DIN 53504:
Electro Mechanical Universal Testing System 5 kN / 50 kN with Precision Load Cell
Electro-Mechanical UTM · 5 kN / 50 kN with Precision Load Cell
Pneumatic Clamping Grips for Consistent Specimen Holding
Pneumatic clamping grips for consistent, high-cycle holding
Equip your lab for DIN 53504 with TensileMill CNC
Adding capacity or replacing older equipment? TensileMill CNC can support your DIN 53504 program. Depending on your specimens, that can include universal testing machines with pneumatic grips and cutting dies for rubber and elastomer specimens. Share your material mix and throughput, and we will recommend a setup that fits DIN 53504.